MIL-P-11087G(ME)
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.)
6.1 Intended use. This pipe is intended for use in conveying refined petroleum products.
6.2 Acquisition requirements. Acquisition documents should specify the following:
a. Title, number, and date of this specification. b. Type and size of pipe required (see 1.2).
c. Issue of DoDISS to be cited in the solicitation, and if required, the specific issue of individual documents referenced (see 2.1.1 and 2.2).
d. Pipe size and wall thickness required (see 3.3.1).
e. Length of pipe required if other than as specified (see 3.3.1)
f. Top coat color if other than as specified (see 3.4). g. When oil coating is required (see 3.4).
h. Level of packing required (see 5.2).
i. Any special marking required (see 5.3).
6.3 International standardization. Certain provisions of this specification (including figure 1, dimensions for grooved ends) are the subject of International Standardization Agreements NATO STANAG 3756. When an amendment, revision or cancellation of this specification is proposed which affects or violates the international agreement concerned, the preparing activity shall take appropriate reconciliation action through international standardization channels, including departmental standardization offices, if required.
6.4 Part or identifying number (PIN). Pipes covered by this specification shall have the part numbering system as follows:
M 11087 - X - XX - XXX - XXX
Prefix
Specification number
Type (see 1.2) Size (see 1.2)
Thickness in thousandths of inches
Length in inches (other than 240 inches)
Example of part number M11087I06280228 (i.e., 19 feet long 6.625 O.D. x .280 in. wall pipe with both ends grooved.)
6.5 Subject term (key word) listing. Grooved, pipe
Pipeline sections, steel
Pipeline
9
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business