MIL-DTL-25995D
ASTM INTERNATIONAL
ASTM B210
-
Aluminum and Aluminum-Alloy Drawn Seamless Tubes
ASTM B221
-
Aluminum and Aluminum-Alloy Extruded Bars, Rods, Wire,
Profiles, and Tube
ASTM B241/B241M
-
Aluminum and Aluminum-Alloy Seamless Pipe and Seamless
Extruded Tube
ASTM B429/B429M
-
Aluminum-Alloy Extruded Structural Pipe and Tube
ASTM B483/B483M
-
Aluminum and Aluminum-Alloy Drawn Tubes for General Purpose
Applications
(Copies of these documents are available from https://www.astm.org or ASTM International, P.O. Box
C700, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959.)
2.4 Order of precedence. In the event of a conflict between the text of this document and the
references cited herein, the text of this document takes precedence. Nothing in this document, however,
supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 First article. When specified (see 6.2), a sample shall be subjected to first article inspection in
accordance with 4.5.
3.2 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or
environmentally preferable materials should be used to the maximum extent possible provided that the
material meets or exceeds the operational and maintenance requirements, and promotes economically
advantageous life cycle cost.
3.3 Alloys, chemical composition, tempers, tensile strength, and heat treatment. Alloys, chemical
composition, tempers, tensile strength, and heat treatment for type A and type B pipes shall as specified
3.3.1 Type A. Structural pipe for non-pressure applications shall be in accordance with one of the
following alloys:
ASTM B210 - 3003-H18, 6061-T6, 6063-T6
ASTM B221 - 3003-H112, 6061-T6, 6063-T6
ASTM B429/B429M - 6061-T6, 6063-T6
ASTM B483/B483M - 3003-H18, 3003-H112
3.3.2 Type B. Seamless pipe for pressure applications shall be in accordance ASTM B241/B241M
alloy 3003-H18, 3003-H112, 6061-T6, or 6063-T6.
3.4 Dimensions and configurations.
3.4.1 Straightness. Straightness shall be in accordance with ANSI H35.2.
3.4.2 Schedule (nominal dimensions). The schedule size shall be 5, 10 or 40 (standard) or 80 (extra
heavy). See table I for outside diameter (OD), inside diameter (ID) dimensions, and wall thickness.
3.4.3 Weights. Weights shall be as specified in table I.
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business