MIL-DTL-15119B(OS)
2.3 Non-Government publications. The following documents form a part of this document to the extent
specified herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or
contract.
ASTM INTERNATIONAL
ASTM E8/E8M
-
Standard Test Methods for Tension Testing of Metallic Materials
ASTM E112
-
Standard Test Methods for Determining Average Grain Size
ASTM E350
-
Standard Test Methods for Chemical Analysis of Carbon Steel, Low Alloy
Steel, Silicon Electrical Steel, Ingot Iron, and Wrought Iron
ASTM E1282
-
Standard Guide for Specifying the Chemical Compositions and Selecting
Sampling Practices and Quantitative Analysis Methods for Metals, Ores,
and Related Materials
(Copies of these documents are available from ASTM International, 100 Barr Harbor Dr., P.O. Box C700, West
Conshohocken, PA 19428-2959 or online at www.astm.org.)
NCSL INTERNATIONAL
ANSI/NCSL Z540.3
-
Requirements for the Calibration of Measuring and Test Equipment
(Copies of this document are available from NCSL International, 2995 Wilderness Place, Suite 107, Boulder, CO
80301-5404 or online at www.ncsli.org.)
SAE INTERNATIONAL
SAE-AMS2253
-
Tolerances, Carbon and Alloy Steel Tubing
SAE-AMS2806
-
Identification Bars, Wire, Mechanical Tubing, and Extrusions, Carbon and
Alloy Steels and Corrosion and Heat-Resistant Steels and Alloys
SAE-AMS2807
-
Identification, Carbon and Low-Alloy Steels, Corrosion and Heat-
Resistant Steels and Alloys, Sheet, Strip, Plate, and Aircraft Tubing
SAE-AMS-H-6875
-
Heat Treatment of Steel Raw Materials
(Copies of these documents are available from SAE World Headquarters, 400 Commonwealth Drive, Warrendale,
PA 15096-0001 or online at www.sae.org.)
2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict between
the text of this document and the references cited herein, the text of this document takes precedence. Nothing in this
document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Manufacture (M101). The tubing shall be drawn from fully killed steel manufactured by either the open
hearth or electric furnace process. M101 indicates this is a major requirement that shall be interpreted in accordance
with 4.3. The classification of 4.3 shall apply for similarly designated critical (Cx) and major (M1xx) requirements
throughout this specification.
3.2 Chemical composition (M102). The chemical composition of the steel shall be as specified in table I,
determined in accordance with 4.4.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business