MIL-T-85048
STANDARD FEDERAL
FED-STD-151 Metals; Test Methods
FED-STD-183 Continuous Identification Marking of Iron and
Steel Products
MILITARY
MIL-STD-163 Steel Mill Products, Preparation for Shipment and Storage
MIL-STD-753 Corrosion-Resistant Steel Parts; Sampling, Inspection and Testing for Surface Passivation
AND10104 Tubing, Steel, Corrosion-Resistant, Round, Standard
Dimensions for
MS33584 Tubing End - Standard Dimensions for Flared
(Unless otherwise indicated, copies of federal and military specifications, standards, and handbooks are available from the Standardization Documents Order Desk, Bldg
4D, 700 Robbins Avenue, Philadelphia, PA 19111-5094.)
2.2 Non-Government publications. The following document(s) form a part of this document to the extent specified herein. Unless otherwise specified, the issues of the documents which are DOD adopted are those listed in the issue of the DODISS specified in the solicitation. Unless otherwise specified, the issues of documents not listed in the DODISS are the issues of the documents cited in the solicitation (see 6.2).
AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM) ASTM A 262 Steels, Austenitic Stainless, Detecting
Susceptibility to Intergranular Attack in
ASTM E 112 Estimating the Average Grain Size of Metals
(Application for copies should be addressed to ASTM, 1916 Race Street, Philadelphia
PA 19103.)
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI B 46.1 Surface Texture (Surface Roughness, Waviness, and Lay)
(Application for copies should be addressed to ANSI, 1430 Broadway, New York, NY
10018.)
(Non-Government standards and other publications are normally available from the organizations that prepare or distribute the documents. These documents also may be available in or through libraries or other informational services.)
2.3 Order of precedence. In the event of a conflict between the text of this document and the references cited herein, the text of this document takes precedence. Nothing in this document, however, supersedes applicable laws and regulation unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Materials. Heating of material shall be accomplished in air or protective atmosphere which will provide a smooth gray surface free from carburization, nitriding, or other deleterious surface effects.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business